Skip to end of metadata
Go to start of metadata

In order to start the test

  • click Run on the Workflow Tree toolbar (a).

or

click Run and Monitor Test (b) on the Workflow Tree.

 

Optionally enter a Test Run Name (c) and a Test Run Description (d) for the current test run. You can also enter or modify the Test Run Name and Test Run Description at any time time in the property grid of the Configure Test section (e).

 

Info: Test Run Name and a Test Run Description appear on the test reports and help to identify past test runs.

 

To run the test in debug mode, check the Debug mode box (f) and then click Run Test (g).

While running a test in debug mode, all replayed sessions will be displayed in the session grid and response bodies will not be purged for easier diagnostic.

 

Note: Debug mode requires more hardware resources on the test machine and should be used only for test troubleshooting. It is not recommended to run debug tests with many VUs.

 

The Test Mix group (h) will show a table with all test cases (or test case groups) and the corresponding mix weights (i) and VU distribution (j). The Mix Weight column may be modified to change the number of VUs that each test case will execute.

  • No labels