Skip to end of metadata
Go to start of metadata

The test will complete after a certain number of iterations are performed by VUs.

  1. Set the Max iterations property to specify the number of iterations to perform.
  2. Set How to count Iterations.
    • Total - The Max iterations will be shared between all VUs. This value must be at least equal to the Number of VUs in Steady Load or Max VU in Step Load. The new VU will start a new iteration only if there are non-started iterations remaining. As a consequence, not all VUs will complete the same number of iterations. Some VUs might not run because by the time they are instantiated, there are no iterations left to execute.
    • Per VU - Each VU will complete the same number of Max iterations.


Note: When the Test Completion Condition is set to Number of Iterations, then all iterations will be always complete.




  • No labels