To start the test,

  • click Run on the Workflow Tree toolbar (a).


  • click Run and Monitor Test (b) on the Workflow Tree.

Optionally enter a Test Run Name (c) and a Test Run Description (d) for the current test run. By default, the Name will be the current Test Profile Name, and the Description will be the Test Profile Description.

Info: Test Run Name and a Test Run Description appear on the test reports and help to identify past test runs.

To run the test in debug mode, check the Debug mode box (f) and then click Run Test (g).

While running a test in debug mode, all replayed sessions will be displayed in the session grid, and response bodies will not be purged for more accessible diagnostic.

Note: Debug mode requires more hardware resources on the test machine and should be used only for test troubleshooting. It is not recommended to debug tests with many VUs. It is not available during distributed tests.

The Test Mix group (h) will show a table with all test cases (or test case groups) and the corresponding mix weights (i) and VU distribution (j). The Mix Weight column may be modified to change the number of VUs that each test case will execute. 

Note: If you are running a distributed test then the VU distribution group (h) will look different as described here.

  • No labels